New Mixture Formation Technology of Direct Fuel Injection Stratified Charge Si Engine (OSKA) - Test Result with Gasoline Fuel Nippon Clean Engine Laboratory Company (NiCE)

Format:

Conference/Event

Author/Creator:

Kato, Satoshi, author.

Conference Name:

1988 SAE International Off-Highway and Powerplant Congress and Exposition (1988-09-12 : Milwaukee, Wisconsin, United States)

Language:

English

Physical Description:

1 online resource

Place of Publication:

Warrendale, PA SAE International 1988

Summary:

The new idea incorporates an impinging part in the central piston cavity. A relatively low injection pressure, lower than that of a conventional IDI Diesel engine, and a single hole fuel nozzle are used. The fuel spray is injected against the impinging part, spreads and forms a fuel-air mixture. Since a comparatively rich fuel-air mixture always stays around the impinging part and ignition is accomplished near the center of the mixture, steady, instantaneous and high-speed combustion is possible.As the fuel-air mixture is formed mostly in the cavity, there is little fuel in the squish area. Therefore, it is possible to prevent end-gas knocking, and in spite of the use of spark ignition, to employ a higher compression ratio than that of the conventional premixed SI engine. Experiments with a single cylinder prototype (4-stroke cycle) engine with gasoline fuel showed that the maximum BMEP was 1.0 MPa and the maximum brake thermal efficiency was 37.7 % (217 g/kW.h). The maximum BMEP is almost equivalent to that of a carbureted automobile gasoline engine, and the brake thermal efficiency is equivalent to that of a Direct Injection Diesel engine with the same displacement volume. Exhaust emission was also measured

Notes:

Vendor supplied data

Publisher Number:

881241

Access Restriction:

Restricted for use by site license