Measurement of Piston and Ring Assembly Friction Instantaneous IMEP Method The University of Michigan, Ann Arbor, MI

Format:

Conference/Event

Author/Creator:

Uras, H. Mehmet, author.

Conference Name:

SAE International Congress & Exposition (1983-02-28 : Detroit, Michigan, United States)

Language:

English

Physical Description:

1 online resource

Place of Publication:

Warrendale, PA SAE International 1983

Summary:

An experimental technique termed the Instantaneous IMEP Method has been developed to measure piston and ring assembly friction. The technique requires very accurate measurements of cylinder pressure, connecting rod force and calculation of inertial forces. Friction force is the difference of these forces in consideration of the slider-crank geometry. A grasshopper linkage has been used to transmit the connecting rod force signal measured by a strain gage bridge. Inertial forces have been calculated with the assumption of distributed connecting rod mass. The test engine was a Chevrolet 5 litre V-8, modified for single cylinder operation. Piston and ring assembly friction has been determined under motoring conditions with and without compression as well as firing. Friction measurements have been made with SAE 30 and 50 grade oils at different temperatures. Boundary friction has been observed especially near top and bottom dead centers. To date the technique has been used only for low speed engine operation

Notes:

Vendor supplied data

Publisher Number:

830416

Access Restriction:

Restricted for use by site license