Fuel Sulfate Content Influence in the Formation of Inorganics Components Deposits in the Engine Injectors with Technologies of Gasoline Direct Injection PSA Peugeot Citroen do Brasil

Format:

Conference/Event

Author/Creator:

Fernandes, Fernandes, author.

Contributor:

Braga, Carlos Valois M.

Braga, Leonardo C.

Braga, Sergio L.

Martins, Ana Rosa

Conference Name:

21st SAE Brasil International Congress and Exhibition (2012-10-02 : Sao Paulo, Brazil)

Language:

English

Physical Description:

1 online resource

Place of Publication:

Warrendale, PA SAE International 2012

Summary:

The development of a four-stroke engine, spark ignition, with direct injection of fuel into the combustion chamber was an important initiative for the global automotive market. The thermodynamic potential of this type of engine and its significant improvement in fuel economy have meant this technology as focus of a large number of research projects, with the objective to understand, develop and improve the system of direct fuel injection.However, to meet new emission limits set by Euro 5 specification, it was necessary to reevaluate the geometry design of the injector, which resulted in the development of a new component with a larger number of holes and with a diameter reduction (multi-holes injector). This change in the project aims to ensure a better spray, optimizing air / fuel ratio and, consequently, a better process of combustion inside the combustion chamber, satisfying the emission limits established by the applicable norms.The processes for preparing the mixture, injection, atomization and air flow control inside the cylinder have been the main source of periodic publications that study the direct injection system. Therefore, this paper purpose is to evaluate the formation of inorganic deposits in the injectors using fuels formulated with different amounts of sulfate.The engine used for running the tests was the EP6CDT of PSA Peugeot Citroën. For this study one has performed tests on test bench and in vehicles (road and dynamometer). Other vehicles, with the same technology available in Brazil, were also tested. The variables evaluated during the project were: the chemical composition of different fuels, the correction factor from the injection time (FRA) and flow through the injectors during the tests.This study has indicated that the injector geometry modification, coupled with tested compositions of gasoline, resulted in the formation of deposits that will be discussed throughout this work

Notes:

Vendor supplied data

Publisher Number:

2012-36-0314

Access Restriction:

Restricted for use by site license