Stainless-Steel Pipe, 1/2 in. (13 Mm) and Larger.

Format:

Book

Author/Creator:

Committee, AWWA Standards.

Contributor:

AWWA Standards Committee, Contributor.

Series:

AWWA Standard C220

AWWA Standard C220 ; v.12

Language:

English

Subjects (All):

Pipe, Steel--Standards.

Water-pipes--Standards.

Local Subjects:

Pipe, Steel--Standards.

Water-pipes--Standards.

Physical Description:

1 online resource (34 p.)

Edition:

1st ed.

Place of Publication:

Denver : American Water Works Assoc., 2011.

Language Note:

English

Summary:

This standard pertains to unannealed austenitic stainless-steel pipe that is straight-seam or spiral-seam welded, 1/2 in. (13 mm) in nominal diameter and larger, and that is intended for the transmission and distribution of water and for use in other wate

Contents:

""Foreword""; ""I. Introduction.""; ""I.A. Background""; ""I.B. History""; ""I.C. Acceptance""; ""II. Special Issues""; ""II.A. Basis of Design""; ""III. Use of This Standard""; ""III.A. Purchaser Options and Alternatives""; ""III.B. Modification to Standard""; ""IV. Major Revisions""; ""V. Comments""; ""Section 1 : GENERAL""; ""Sec. 1.1 Scope""; ""Sec. 1.2 Purpose""; ""Sec. 1.3 Application""; ""Section 2: REFERENCES""; ""Section 3: DEFINITIONS""; ""Section 4: REQUIREMENTS ""; ""Sec. 4.1 Permeation""; ""Sec. 4.2 Materials""; ""Sec. 4.3 General Fabrication Requirements""

""Sec. 4.4 Specific Fabrication Requirements""""Sec. 4.5 Permissible Variations in Weights and Dimensions""; ""Sec. 4.6 Preparation of Ends""; ""Sec. 4.7 Special Ends""; ""Sec. 4.8 Cleaning and Descaling""; ""Sec. 4.9 Specials and Fittings""; ""Section 5: VERIFICATION""; ""Sec. 5.1 Inspection""; ""Sec. 5.2 Test Procedures""; ""Sec. 5.3 Basis for Rejection""; ""Sec. 5.4 Repair of Defects""; ""Section 6: DELIVERY""; ""Sec. 6.1 Marking""; ""Sec. 6.2 Shipping, Storage, and Handling""; ""Sec. 6.3 Affidavit of Compliance""; ""Figures ""

""Figure 1 Repair method by offset value and well thickenss """"Figure 2 Reduced-section tension test specimen ""; ""Figure 3 Guided-bend test specimen ""; ""Figure 4 Jig for guided-bend test ""; ""Figure 5 Alternative guided-bend wraparound jig ""; ""Figure 6 Alternative guided-bend roller jig ""; ""Tables ""; ""Table 1 Mechanical properties for austenitic or duplex stainless steel ""; ""Table 2 Re pair requirements based on offset value and wall thickness""; ""Table 3 Guided-bend test jig dimensions ""

Notes:

Description based upon print version of record.

ISBN:

1-61300-145-2